Towbar Wiring loom Kit
|
Feature |
Benefit |
|
Uses Factory installed wiring already in the vehicle. |
Small front and rear harness, quick easy fitment (under 10mins) as per Ford factory unit. |
|
Uses Ford derived Can Bus software. |
Integrates with the vehicle systems such as sway control and other safety features. Can be coded if required on the Ford system(comfort features) |
|
Prewired for Brake controller |
Simple under seat controller connection, no need to find brake signal and run wiring to the back. |
|
99.9% LED compatible |
No need to use a resistor pack for proper LED operation. |
|
Is manufactured in a Q1 certified plant which also supplies Ford Europe a significant volume of its OEM tow bar harnesses. |
The manufacturer is certified by Ford as to its quality and standards meeting the Ford Q1 level, which ensures it is an OEM quality kit.( there is no other Q1 manufacturer in Australasia.) |
|
Full detailed Instructions. |
Which means easy straight forward installation. |
|
All connections use Ford Factory connectors |
Ensures correct installation and eliminates the risk of causing other electrical issues which need to be dealer corrected. |
Note: This loom will also allow the rear sensors to be turned off when reversing. deactivating the PCD (rear parking sensors). However, this will need to be programmed by your Ford Delaer at your next service.
